User Manual
Table Of Contents
- Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Computer Software Copyrights
- Handling Precautions
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Non-Connect Plus Operations
- Additional Radio Controls in Non-Connect Plus Mode
- Making and Receiving Calls in Non-Connect Plus Mode
- Advanced Features in Non-Connect Plus Mode
- Scan Lists
- Scan
- Vote Scan
- Call Indicator Settings
- Call Alert Operation
- Emergency Operation
- Man Down
- Text Message Features
- Privacy
- Multi-Site Controls
- Lone Worker
- Password Lock Features
- Bluetooth Operation
- Auto-Range Transponder System (ARTS)
- Over-the-Air-Programming (OTAP)
- Wi-Fi Operation
- Utilities
- Setting the Power Level
- Turning the Option Board Feature(s) On or Off
- Turning the Voice Operating Transmission (VOX) Feature On or Off
- Turning the Radio Tones/Alerts On or Off
- Checking the Battery Strength
- Turning the Voice Announcement On or Off
- Setting the Text-to-Speech Feature
- Switching Audio Route between Internal Radio Speaker and Wired Accessory
- Intelligent Audio
- Turning the Acoustic Feedback Suppressor Feature On or Off
- Turning GPS/GNSS On or Off
- Flexible Receive List
- Connect Plus Operations
- Additional Radio Controls in Connect Plus Mode
- Making and Receiving Calls in Connect Plus Mode
- Advanced Features in Connect Plus Mode
- Accessories
- Maritime Radio Use in the VHF Frequency Range
- Batteries and Chargers Warranty
- Limited Warranty
- Blank Page
tery when the programmed Battery
Strength button is pressed.
Blinking
green
Radio is powering up, receiving a
non-privacy- enabled call or data.
Double
blinking
green
Radio is receiving a privacy-enabled
call.
Indicator Tones
High pitched tone Low pitched tone
Positive Indicator Tone
Negative Indicator Tone
Alert Tones
Alert tones provide you with audible indications of the
status, or response to data received on the radio.
Continuous Tone A monotone sound.
Sounds continuously un-
til termination.
Periodic Tone Sounds periodically de-
pending on the duration
set by the radio. Tone
starts, stops, and repeats
itself.
Repetitive Tone A single tone that re-
peats itself until it is ter-
minated by the user.
Momentary Tone Sounds only once for a
short period of time de-
fined by the radio.
Switching Between Connect Plus and Non-
Connect Plus Modes
To switch to a non-Connect Plus mode, you must
change to another zone, if programmed by your
dealer or system administrator. Check with your
dealer or system administrator to see if your radio has
been programmed with non-Connect Plus zones, and
what features are available while operating in non-
Connect Plus zones.
Additional Radio Controls in Connect Plus Mode
70
English