User Manual
Table Of Contents
- Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Computer Software Copyrights
- Handling Precautions
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Non-Connect Plus Operations
- Additional Radio Controls in Non-Connect Plus Mode
- Making and Receiving Calls in Non-Connect Plus Mode
- Advanced Features in Non-Connect Plus Mode
- Scan Lists
- Scan
- Vote Scan
- Call Indicator Settings
- Call Alert Operation
- Emergency Operation
- Man Down
- Text Message Features
- Privacy
- Multi-Site Controls
- Lone Worker
- Password Lock Features
- Bluetooth Operation
- Auto-Range Transponder System (ARTS)
- Over-the-Air-Programming (OTAP)
- Wi-Fi Operation
- Utilities
- Setting the Power Level
- Turning the Option Board Feature(s) On or Off
- Turning the Voice Operating Transmission (VOX) Feature On or Off
- Turning the Radio Tones/Alerts On or Off
- Checking the Battery Strength
- Turning the Voice Announcement On or Off
- Setting the Text-to-Speech Feature
- Switching Audio Route between Internal Radio Speaker and Wired Accessory
- Intelligent Audio
- Turning the Acoustic Feedback Suppressor Feature On or Off
- Turning GPS/GNSS On or Off
- Flexible Receive List
- Connect Plus Operations
- Additional Radio Controls in Connect Plus Mode
- Making and Receiving Calls in Connect Plus Mode
- Advanced Features in Connect Plus Mode
- Accessories
- Maritime Radio Use in the VHF Frequency Range
- Batteries and Chargers Warranty
- Limited Warranty
- Blank Page
Press the programmed Bluetooth Audio Switch
button.
A tone sounds when the audio route has switched.
Permanent Bluetooth Discoverable Mode
Note:
The Permanent Bluetooth Discoverable Mode
can only be enabled via the MOTOTRBO
CPS. If enabled, you will not be able to use
any Bluetooth programmable button features.
Other Bluetooth-enabled devices can locate your
radio, but the devices cannot connect to the radio. It
enables dedicated devices to use your radio position
in the process of Bluetooth-based location.
Auto-Range Transponder System (ARTS)
ARTS is an analog-only feature designed to inform
you when your radio is out-of-range of other ARTS-
equipped radios.
ARTS-equipped radios transmit or receive signals
periodically to confirm that they are within range of
each other. Your dealer can program your radio to
transmit or receive the ARTS signal.
Your radio provides indications of states as follows:
• First-Time Alert – A tone sounds.
• ARTS-in-Range Alert – A tone sounds, if
programmed.
• ARTS-Out-of-Range Alert – A tone sounds, the
LED rapidly blinks red.
Over-the-Air-Programming (OTAP)
Your radio can be updated by your dealer remotely,
via OTAP, without needing to be physically
connected. Additionally, some settings can also be
configured via OTAP.
While undergoing OTAP, the LED blinks green
.
Note:
When the radio is receiving high volume data,
the High Volume Data icon appears and
channel is busy. A PTT button press at this
time may cause a negative tone to sound.
Once the programming is complete, a tone sounds,
and your radio restarts (powers off and on again).
Wi-Fi Operation
Wi-Fi
®
is a registered trademark of Wi-Fi Alliance
®
.
Advanced Features in Non-Connect Plus Mode
59
English