User Manual

• Channel Selector Knob positions 1 to 9 represent
numbers 1 to 9; position 10 represents the number
0.
• Side Buttons 1 to 3
represent numbers 1 to 3.
Accessing the Radio from Password
1 Power up your radio.
You hear a continuous tone.
2 Use the Channel Selector Knob to enter the first
digit of the password.
3 Press Side Button 1, 2 or 3
to enter each digit of
the remaining three digits of the password.
You hear a positive indicator tone for every digit
entered. When the second digit of the password is
entered, your radio ignores any Channel Selector
Knob position change. When the last digit of the
four-digit password is entered, your radio
automatically checks the validity of the password.
If the password is correct, your radio proceeds to
power up. See Powering Up the Radio on page
21.
If the password is incorrect, you hear a continuous
tone. Repeat Steps 2 and 3.
After the third incorrect password, your radio
enters into locked state. A tone sounds and the
LED double blinks yellow.
Your radio enters into locked state for 15 minutes,
and responds to inputs from only.
Note:
The radio is unable to receive any call,
including emergency calls, in locked state.
Unlocking the Radio from Locked State
1 If your radio was powered down after being in the
locked state, power up the radio.
A tone sounds and the LED double blinks yellow.
2 Wait for 15 minutes.
Your radio restarts the 15 minutes timer for locked
state when you power up.
3 Repeat Steps 1 and 2 in Accessing the Radio from
Password on page 57.
Advanced Features in Non-Connect Plus Mode
57
English