User Manual
Table Of Contents
- Contents
- Declaration of Conformity
- Important Safety Information
- Software Version
- Computer Software Copyrights
- Handling Precautions
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Non-Connect Plus Operations
- Additional Radio Controls in Non-Connect Plus Mode
- Making and Receiving Calls in Non-Connect Plus Mode
- Advanced Features in Non-Connect Plus Mode
- Scan Lists
- Scan
- Vote Scan
- Call Indicator Settings
- Call Alert Operation
- Emergency Operation
- Man Down
- Text Message Features
- Privacy
- Multi-Site Controls
- Lone Worker
- Password Lock Features
- Bluetooth Operation
- Auto-Range Transponder System (ARTS)
- Over-the-Air-Programming (OTAP)
- Wi-Fi Operation
- Utilities
- Setting the Power Level
- Turning the Option Board Feature(s) On or Off
- Turning the Voice Operating Transmission (VOX) Feature On or Off
- Turning the Radio Tones/Alerts On or Off
- Checking the Battery Strength
- Turning the Voice Announcement On or Off
- Setting the Text-to-Speech Feature
- Switching Audio Route between Internal Radio Speaker and Wired Accessory
- Intelligent Audio
- Turning the Acoustic Feedback Suppressor Feature On or Off
- Turning GPS/GNSS On or Off
- Flexible Receive List
- Connect Plus Operations
- Additional Radio Controls in Connect Plus Mode
- Making and Receiving Calls in Connect Plus Mode
- Advanced Features in Connect Plus Mode
- Accessories
- Maritime Radio Use in the VHF Frequency Range
- Batteries and Chargers Warranty
- Limited Warranty
- Blank Page
Call Alert Operation
Call Alert paging enables you to alert a specific radio
user to call you back when they are able to do so.
This feature is accessible via a programmed One
Touch Access
button.
Receiving and Responding to a Call Alert
When you receive a Call Alert page, you hear a
repetitive tone and the LED blinks yellow.
Making a Call Alert with the One Touch Access Button
Press the programmed One Touch Access
button to make a Call Alert to the predefined alias
or ID.
The LED lights up solid green when your radio is
sending the Call Alert.
If the Call Alert acknowledgement is received, two
chirps sound.
If the Call Alert acknowledgement is not received,
a low-pitch tone sounds.
Emergency Operation
An Emergency Alarm is used to indicate a critical
situation. You are able to initiate an Emergency at
any time, in any state, even when there is activity on
the current channel.
Your dealer can set the duration of a button press for
the programmed Emergency button, except for long
press, which is similar with all other buttons:
Short press Between 0.05 seconds and 0.75
seconds.
Long press Between 1.00 second and 3.75
seconds.
The Emergency button is assigned with the
Emergency On/Off feature. Check with your dealer for
the assigned operation of the Emergency button.
Note:
If the short press for the Emergency button is
assigned to turn on the Emergency mode,
then the long press for the Emergency button
is assigned to exit the Emergency mode.
Advanced Features in Non-Connect Plus Mode
48
English