User's Manual

13
Grant of Equipment Authorization
FCC Interference
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
FCC Notice:
IMPORTANT: Unauthorized repairs or modifications could result in
permanent damage to the equipment and void your warranty and your
authority to operate this device under Part 15 of the FCC Rules.
IMPORTANT: This device is capable of operating in 802.11a mode. For
802.11a devices, operating in the frequency range of 5.15 - 5.25 GHz, they
are restricted for indoor operations to reduce any potential harmful
interference for Mobile Satellite Services (MSS) in the US. WIFI Access
Points that are capable of allowing your device to operate in 802.11a
mode (5.15 - 5.25 GHz band) are optimized for indoor use only. If your WIFI
network is capable of operating in this mode, please restrict your WIFI
use indoors to not violate federal regulations to protect Mobile Satellite
Services.
Radio Frequency and Power
* 802.11n is only applicable for EWP2200/EWP3200.
FCC Grant of Equipment Authorization
Industry Canada Grant of Equipment Authorization
This Class B digital apparatus complies with Canadian ICES-003. Cet
appreil numérique de la classe B est conforme à la norme NMB-003 du
Canada:
Radio Network Freq Band Rated Power
802.11a
(only for 2100
& 3100)
WLAN 5.15-5.25 GHz
5.25-5.35 GHz
5.47-5.725 GHz
5.725-5.825 GHz
15.8mW at 54Mbps
802.11a/n
*
WLAN 5.15-5.25 GHz
5.25-5.35 GHz
5.47-5.725 GHz
5.725-5.850 GHz
802.11a: 15.8mW at 54Mbps
802.11n (5GHz): 12.59mW at MCS7
802.11b WLAN 2412-2462MHz
2412-2472 MHz
63mW at 11Mbps (US & Canada)
25.12mW at 11Mbps (EU)
802.11g/n
*
WLAN 2412-2462MHz
2412-2472 MHz
17.8mW at 54 Mbps/MCS7 (US, Canada
& EU)
25.12mW at 6Mbps/MCS0 (EU)
Bluetooth WPAN 2402-2480MHz 1mW (for EWP2100 & 3100)
7mW (for EWP2200 & 3200)
Model FCC ID Model FCC ID
EWP2100 AZ489FT7032 EWP2200 AZ489FT7052
EWP3100 AZ489FT7038 EWP3200 AZ489FT7051
Model IC ID Model IC ID
EWP2100 109U-89FT7032 EWP2200 109U- 89FT7052
EWP3100 109U-89FT7038 EWP3200 109U- 89FT7051
EWP2000_3000_QSG.book Page 13 Monday, April 30, 2012 4:10 PM