User's Manual

11
Headset Connection
PTT and stereo headsets
Use your headset jack to plug in
an optional PTT headset.
Warning: When using a
headset, you may not hear the
surrounding sounds. Do not use
a headset where it can endanger
your safety.
First time connection of Bluetooth
headset
• The headset must be charged prior to starting.
• Bluetooth headset must be turned Off.
1. To turn on Bluetooth on the EWP: press Start >
Settings > Connections > Wireless Manager,
check the Enable Bluetooth box and press
Done. The
h indicator appears in the Home
screen.
2. From the Home screen, press: Start > All
Programs > Bluetooth > Bluetooth Manager >
Hands-free.
3. Turn the headset on and place it in pairing
mode (Refer to the Bluetooth pairing
instructions included with the headset.). When
using a Motorola headset, press and hold the
Call button of the headset for 5 seconds. The
indicator light turns on and remains steady. If
the indicator light is flashing or does not
remain steadily lit, turn off/on the headset and
repeat this step.
4. On the EWP press: Add. The EWP prompts you
to verify your headset is ready.
5. Press: Search. The EWP starts searching for
your headset and shows it on the screen.
6. Press: Select to connect the headset.
7. When prompted, enter the device passkey
provided with your headset (such as 0000) and
press Accept.
When your headset successfully pairs, the indicator
light changes from steady to flashing blue. After
you have successfully paired your device and
headset, you do not need to repeat these steps.
To pair the headset again, verify that your EWP’s
Bluetooth is enabled (See step 1.) and turn on the
headset.
EWP2000_3000_QSG.book Page 11 Monday, April 30, 2012 4:10 PM