User's Guide

3 To initiate searching, press the Menu Select
button directly below CSrh once the entry is done.
To exit this procedure, press the Menu Select
button directly below Cncl.
The display shows Searching. Once found, the
display shows the matched channel name and the
radio changed its transmission to the selected
channel.
If the radio is triggered to search for an empty entry,
the display shows Invalid entry. Repeat step 2 to
search again.
If the entry does not match, the display shows
Channel name not found. Repeat step 2 to search
again; or press
or the Menu Select button directly
below Exit
to exit.
Mode Select Feature
Mode Select allows a long press to save your radio’s
current zone and channel to a programmable button,
keypad button or a softkey; then once programmed,
the short-press of that button or softkey changes the
transmission to the saved zone and channel.
There are two methods to save the selected zone and
channel:
•
Softkeys
• Programmable buttons and keypad buttons (digit 0
to 9)
Note: Your radio must be preprogrammed to allow
you to use this feature.
Saving a Zone and a Channel to a Softkey
Five softkeys are available for you to save the
frequently used zone and channel.
1 Toggle your zone and channel to the required
zone and channel.
2
or to MS1, MS2 ... or MS5.
3 Press and hold the Menu Select button directly
below one of the softkey (MS1–MS5).
You hear a short, medium-pitched tone when the
zone and channel is saved.
Note: To change the programmed zone and channel,
repeat this procedure.
General Radio Operation
56
English