User's Guide

Pairing with LEX 700
Ensure that Bluetooth feature of your radio is on and
the Bluetooth tones are enabled.
1 Turn on the LEX 700 and activate the Bluetooth
feature.
2 Place the LEX 700 close to the radio aligning the
Bluetooth Pairing Location on LEX 700 with the
Bluetooth Pairing Location on the radio.
If the pairing process is successful, you hear an
incremental-pitched tone from the radio. The radio
begins to connect to LEX 700. If the connecting
process is successful, you hear an incremental-
pitched tone. The display shows LEX 700
connected, and the Bluetooth icon turns from
to .
If unsuccessful, one of the following scenarios will
occur:
• You hear a short, low-pitched tone and the
display shows Bluetooth pairing failed
(if
pairing fails).
• You hear a decremental-pitched tone and the
display shows LEX 700 unpaired
(if the
connection fails within 6 seconds).
•
You hear a short, low-pitched tone and the
display shows LEX 700 connect failed (if
the radio has the pairing record of LEX 700 and
the connection fails).
Repeat this step to re-initiate the pairing process.
Note: To unpair the LEX 700 after a successful
connection, follow the steps in .
Programming Over Project 25 (POP 25)
(ASTRO 25 and ASTRO Conventional)
This feature enables configuration data to be
upgraded to your radio over-the-air. This feature
retains full use of the radio during the configuration
data transfer without interrupting communication. The
upgrade pauses to give priorities to voice call, and
continues after the voice call ended.
Once a configuration upgrade is downloaded to your
radio, you can install new changes immediately or
delay changes to be installed on the radio when it is
being powered up.
Advanced Features
145
English