User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Notational Conventions
- Welcome
- What is the HC700-G Handheld Computer?
- Unpacking
- HC700-G Features
- Charging the Battery
- Figure 3. HC700-G Personal Desktop Cradle
- Battery Replacement
- Figure 4. Battery Installation and Removal
- 1. Hold down the Power Button for at least four seconds until the HC700-G screen turns off.
- 2. Remove the HC700-G hand-strap (see Figure 4).
- 3. Press the battery snap on the battery (see Figure 4) and pull away the battery from the HC700-G.
- 4. Insert a fresh battery, bottom end first, into the battery compartment.
- 5. Carefully, press the battery top downward until it clicks and locks in place.
- 6. Press the Power Button - the HC700-G is now ready for use.
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Disposal
- To Prevent Injury or Burns
- Using the HC700-G
- Starting to Work
- Turning On
- Turning Off
- Suspend Mode
- The Status LED
- The Application LED
- Making a Call
- Voice Recording
- Using the Keypad
- Direct Action Keys
- Scanning Barcodes and Capturing Images
- Figure 7. Capturing Images with the HC700-G Imager
- 1. Run the Bcr barcode reader application: Start Menu- >Programs->Sample Applications->Bcr.
- 2. Aim and hold the HC700-G at 2 to 12 inches (5 to 30 cm) distance from the target.
- 3. Press one of the Scan keys and aim the green aiming bar towards the target to adjust your posi...
- Resetting the HC700-G
- Mini SD Memory Card
- Installing a Mini SD Card
- Mini SD Card Handling Precautions
- SIM Card Installation
- Figure 12. SIM Card Installation
- 1. Remove the battery.
- 2. Open the SIM card door
- 3. Slide the SIM card holder forward to unlock the SIM card
- 4. Slide the new SIM card in the holder with the cut corner on the upper right and the gold plate...
- 5. Lower the SIM card holder and press downward to lock the SIM card holder
- 6. Close the SIM card door
- 7. Install the battery
- Service
- ActiveSync (USB) Connectivity
- Troubleshooting
24
Cleaning Procedure
If the battery contacts, screen or surface of the HC700-G
becomes dirty, use a soft lint cloth moistened with diluted
Isopropyl Alcohol (IPA) solution to remove dirt. The Isopropyl
Alcohol (IPA) can be diluted with water up to 20%.
ActiveSync (
USB) Connectivity
The ActiveSync over USB enables the user to explore and
manage the HC700-G from remote, transfer files (data
images etc.) and surf the Internet via host PC.
First Time Connection
In order to enable USB communication with your host PC,
Microsoft ActiveSync program must be installed on your PC.
The HC700-G is provided with the ActiveSync program
installed. However, the program can be obtained from
Microsoft web site. To learn more about most up-to-date ver-
sion of the ActiveSync and its operation, refer to ActiveSync
help.
Connect the USB cable between the HC700-G and PC. Your
PC will identify the new connection and will request you to
point to the HC700-G software driver (wceusbsh.inf) provided
with this product.
Routine Connection
Just hook the USB cable from the HC700-G to your PC - the
ActiveSync icon will become green and a Partnership window
will show. Check the Guest Partnership and click Next to
popup the ActiveSync program.
Figure 13. USB Connectivity
PC USB Port
Host PC
HC700-G Port
Enhanced IMD Users.book Page 24 Thursday, February 9, 2006 11:52 AM