User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Notational Conventions
- Welcome
- What is the HC700-G Handheld Computer?
- Unpacking
- HC700-G Features
- Charging the Battery
- Figure 3. HC700-G Personal Desktop Cradle
- Battery Replacement
- Figure 4. Battery Installation and Removal
- 1. Hold down the Power Button for at least four seconds until the HC700-G screen turns off.
- 2. Remove the HC700-G hand-strap (see Figure 4).
- 3. Press the battery snap on the battery (see Figure 4) and pull away the battery from the HC700-G.
- 4. Insert a fresh battery, bottom end first, into the battery compartment.
- 5. Carefully, press the battery top downward until it clicks and locks in place.
- 6. Press the Power Button - the HC700-G is now ready for use.
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Disposal
- To Prevent Injury or Burns
- Using the HC700-G
- Starting to Work
- Turning On
- Turning Off
- Suspend Mode
- The Status LED
- The Application LED
- Making a Call
- Voice Recording
- Using the Keypad
- Direct Action Keys
- Scanning Barcodes and Capturing Images
- Figure 7. Capturing Images with the HC700-G Imager
- 1. Run the Bcr barcode reader application: Start Menu- >Programs->Sample Applications->Bcr.
- 2. Aim and hold the HC700-G at 2 to 12 inches (5 to 30 cm) distance from the target.
- 3. Press one of the Scan keys and aim the green aiming bar towards the target to adjust your posi...
- Resetting the HC700-G
- Mini SD Memory Card
- Installing a Mini SD Card
- Mini SD Card Handling Precautions
- SIM Card Installation
- Figure 12. SIM Card Installation
- 1. Remove the battery.
- 2. Open the SIM card door
- 3. Slide the SIM card holder forward to unlock the SIM card
- 4. Slide the new SIM card in the holder with the cut corner on the upper right and the gold plate...
- 5. Lower the SIM card holder and press downward to lock the SIM card holder
- 6. Close the SIM card door
- 7. Install the battery
- Service
- ActiveSync (USB) Connectivity
- Troubleshooting
22
Hold down the Power Button and <S> and <X> keys for at
least 5 seconds (see Figure 11); the HC700-G will restart its
operating system.
Mini SD Memory Card
Installing a Mini
SD Card
Important: Turn the
HC700-G power off before
removing or installing the
Mini SD (Secure Digital)
card.
1. Turn off the HC700-G.
2. Remove the cover
screw to access the Mini SD card slot (see Figure 11).
3. Insert the Mini SD card as shown in Figure 11.
Mini SD Card Handling Precautions
• Use only the supplied Mini SD card.
• Do not bend or apply force to the Mini SD card.
• Do not store the Mini SD card in locations subjected to
high humidity or temperatures.
SIM Card Installation
To install or replace a
SIM card, perform the
following steps:
1. Remove the bat-
tery.
2. Open the SIM
card door
3. Slide the SIM
card holder for-
ward to unlock
the SIM card
4. Slide the new SIM card in the holder with the cut corner
on the upper right and the gold plate facing down
Figure 11. Mini SD Card Installation
Figure 12. SIM Card Installation
SIM Card Door
SIM Card Holder
Enhanced IMD Users.book Page 22 Thursday, February 9, 2006 11:52 AM