User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Notational Conventions
- Welcome
- What is the HC700-G Handheld Computer?
- Unpacking
- HC700-G Features
- Charging the Battery
- Figure 3. HC700-G Personal Desktop Cradle
- Battery Replacement
- Figure 4. Battery Installation and Removal
- 1. Hold down the Power Button for at least four seconds until the HC700-G screen turns off.
- 2. Remove the HC700-G hand-strap (see Figure 4).
- 3. Press the battery snap on the battery (see Figure 4) and pull away the battery from the HC700-G.
- 4. Insert a fresh battery, bottom end first, into the battery compartment.
- 5. Carefully, press the battery top downward until it clicks and locks in place.
- 6. Press the Power Button - the HC700-G is now ready for use.
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Disposal
- To Prevent Injury or Burns
- Using the HC700-G
- Starting to Work
- Turning On
- Turning Off
- Suspend Mode
- The Status LED
- The Application LED
- Making a Call
- Voice Recording
- Using the Keypad
- Direct Action Keys
- Scanning Barcodes and Capturing Images
- Figure 7. Capturing Images with the HC700-G Imager
- 1. Run the Bcr barcode reader application: Start Menu- >Programs->Sample Applications->Bcr.
- 2. Aim and hold the HC700-G at 2 to 12 inches (5 to 30 cm) distance from the target.
- 3. Press one of the Scan keys and aim the green aiming bar towards the target to adjust your posi...
- Resetting the HC700-G
- Mini SD Memory Card
- Installing a Mini SD Card
- Mini SD Card Handling Precautions
- SIM Card Installation
- Figure 12. SIM Card Installation
- 1. Remove the battery.
- 2. Open the SIM card door
- 3. Slide the SIM card holder forward to unlock the SIM card
- 4. Slide the new SIM card in the holder with the cut corner on the upper right and the gold plate...
- 5. Lower the SIM card holder and press downward to lock the SIM card holder
- 6. Close the SIM card door
- 7. Install the battery
- Service
- ActiveSync (USB) Connectivity
- Troubleshooting
21
Resetting the HC700-G
You may need to reset the HC700-G; for example, you may
need to reset due to communication cut-off, or if the operat-
ing system or the application stops responding.
If the HC700-G stops responding, perform the following
steps:
Step 1: Warm
Reset
Important Note: When
the HC700-G performs
Warm Reset, all
recorded information
remains stored in mem-
ory.
Hold down the <ESC>
and <A> and <F> keys
(see Figure 9) for at least
5 seconds - the Motor-
ola logo will show on the screen for about 30 seconds and
then Windows Mobile desktop or application screen will
appear - the HC700-G functions again.
If the HC700-G still does
not respond, perform
“Step 2: Cold Reset”:
Step 2: Cold Reset
Cold Reset restarts the
HC700-G by erasing all
stored records and
entries.
Do Not perform Cold
Reset unless Warm
Reset fails to solve the
problem.
Figure 9. Warm Reset - Key Combination
Figure 10. Cold Reset - Key Combination
Enhanced IMD Users.book Page 21 Thursday, February 9, 2006 11:52 AM