User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Notational Conventions
- Welcome
- What is the HC700-G Handheld Computer?
- Unpacking
- HC700-G Features
- Charging the Battery
- Figure 3. HC700-G Personal Desktop Cradle
- Battery Replacement
- Figure 4. Battery Installation and Removal
- 1. Hold down the Power Button for at least four seconds until the HC700-G screen turns off.
- 2. Remove the HC700-G hand-strap (see Figure 4).
- 3. Press the battery snap on the battery (see Figure 4) and pull away the battery from the HC700-G.
- 4. Insert a fresh battery, bottom end first, into the battery compartment.
- 5. Carefully, press the battery top downward until it clicks and locks in place.
- 6. Press the Power Button - the HC700-G is now ready for use.
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Disposal
- To Prevent Injury or Burns
- Using the HC700-G
- Starting to Work
- Turning On
- Turning Off
- Suspend Mode
- The Status LED
- The Application LED
- Making a Call
- Voice Recording
- Using the Keypad
- Direct Action Keys
- Scanning Barcodes and Capturing Images
- Figure 7. Capturing Images with the HC700-G Imager
- 1. Run the Bcr barcode reader application: Start Menu- >Programs->Sample Applications->Bcr.
- 2. Aim and hold the HC700-G at 2 to 12 inches (5 to 30 cm) distance from the target.
- 3. Press one of the Scan keys and aim the green aiming bar towards the target to adjust your posi...
- Resetting the HC700-G
- Mini SD Memory Card
- Installing a Mini SD Card
- Mini SD Card Handling Precautions
- SIM Card Installation
- Figure 12. SIM Card Installation
- 1. Remove the battery.
- 2. Open the SIM card door
- 3. Slide the SIM card holder forward to unlock the SIM card
- 4. Slide the new SIM card in the holder with the cut corner on the upper right and the gold plate...
- 5. Lower the SIM card holder and press downward to lock the SIM card holder
- 6. Close the SIM card door
- 7. Install the battery
- Service
- ActiveSync (USB) Connectivity
- Troubleshooting
19
Virtual Keyboard
To display the virtual keyboard - hold down the <SHIFT> and
<SP> and Scan/Picture Button.
Scanning Barcodes and Capturing Images
The HC700-G houses a digital camera (imager) that captures
pictures and scans the most commonly used 1D and 2D bar-
codes. The HC700-G supports 360
° omni-directional capture
for easy use in daily work. The imager captures digital
images, such as signatures, text or pictures of any object or
paper form. The images are stored in the HC700-G memory.
20
o
Vertical angle of
barcode capture
40
o
horizontal angle of
barcode capture
Hold 2 to 12 Inches from target
Red Ambient Light
Aim the green light
bar at the barcode
20
o
40
o
Scan/Picture Key
Scan/Picture Ke
y
s
Figure 7. Capturing Images with the HC700-G Imager
CLASS 1 LED PRODUCT
IEC 60825-1 ED 1.2:2001
Enhanced IMD Users.book Page 19 Thursday, February 9, 2006 11:52 AM