User's Manual

10
Using the HC700-G
Starting to Work
Place the battery in the HC700-G to boot-up and press the
Power Button (see Figure 1) to turn on the HC700-G; the
Motorola logo will show for about 30 seconds and Windows
Mobile screen will appear. The Windows Mobile screen will
ask the user to tap on the screen and will instruct to follow
the Align Screen procedure (touch screen calibration).
Turning On
Whenever the HC700-G screen is off, press the Power Button
(see Figure 1) to turn on the HC700-G and resume operation.
Important: do not
press the Power Button when the HC700-
G is out of the cradle and the Status LED (inside the Power
button) is red.
Turning Off
Turn off the HC700-G when not in use for long duration and
when charging is not available.
To turn off the HC700-G perform the following:
While the HC700-G is turned on, hold down the Power Button
for at least four seconds - the HC700-G will store the infor-
mation of the last used program screen and will shift to off
mode - no information will be lost.
Once turned on again, the HC700-G will return to the last pro-
gram screen that was in use.
Suspend Mode
Use Suspend mode as often as possible during daily use to
conserve battery power. For power saving, the HC700-G will
automatically turn to Suspend after 1 minute (default). To
configure the time duration before the HC700-G enters Sus-
pend mode, go to: Start Menu->Settings->System->Power-
>Advanced (duration range is 0 to 5 minutes).
To manually shift to Suspend mode - while the HC700-G is
turned on, momentarily press the Power Button (see Figure
1).
Enhanced IMD Users.book Page 10 Thursday, February 9, 2006 11:52 AM