User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Introduction
- What is the X-Pad Terminal
- Unpacking
- X-Pad Parts
- Charging the Battery
- Figure 3. Battery Installation and Removal
- Battery Installation and Removal
- 1. Insert the battery, bottom end first, into the battery compartment (see Figure 3).
- 2. Carefully press the battery top downward until it clicks into place. When X-Pad is powered by ...
- 1. Turn the X-Pad off by holding the Power button pressed (see Figure 1), for at least four seconds.
- 2. Press the Release Buttons on the battery sides (see Figure 3) and pull away the battery from t...
- The Universal Office Dock (UOD) Unit
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Storage
- Extending Battery Life
- Using the X-Pad
- Maintaining the X-Pad
- Accessories
- Troubleshooting
- Safety Instructions
- SPECIFICATIONS
tribution, or reverse engineering of such MOTOROLA software or exercise of rights in such MOTOROLA
software is permitted. No license is granted by implication, estoppel or otherwise under MOTOROLA patent
rights or copyrights.
VII. Governing Law
This Warranty is governed by the laws of the State of Illinois, USA.
Grant of Equipment Authorization
FCC Grant of Equipment Authorization
FCC ID: AZ489FT7010
Canada Grant of Equipment Authorization
IC: 109U-89FT7010
EPS – 48759 – O
FCC INTERFERENCE
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residen-
tial installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Radio Network Freq Band Rated Power
Wi-Fi 802.11b W-LAN 2412 - 2462MHz 16 mW
Bluetooth W-PAN 2402 - 2480MHz 1 mW
GPRS W-WAN 824.2 - 848.8 MHz / 1850.2 - 1909.8 MHZ 0.631 / 0.809 W