User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Introduction
- What is the X-Pad Terminal
- Unpacking
- X-Pad Parts
- Charging the Battery
- Figure 3. Battery Installation and Removal
- Battery Installation and Removal
- 1. Insert the battery, bottom end first, into the battery compartment (see Figure 3).
- 2. Carefully press the battery top downward until it clicks into place. When X-Pad is powered by ...
- 1. Turn the X-Pad off by holding the Power button pressed (see Figure 1), for at least four seconds.
- 2. Press the Release Buttons on the battery sides (see Figure 3) and pull away the battery from t...
- The Universal Office Dock (UOD) Unit
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Storage
- Extending Battery Life
- Using the X-Pad
- Maintaining the X-Pad
- Accessories
- Troubleshooting
- Safety Instructions
- SPECIFICATIONS
25
Backup Battery Rechargeable 90 mAh Lithium coin cell (not
user replaceable)
4 hour preservation of RTC and memory
Minimum 1000+ 10% discharge/charge
cycles
Minimum 40+ 100% discharge/charge
cycles
Software
Operating System PocketPC 2003
Power Management As supported by PocketPC 2003: Run, Idle,
Stand By, Docked.
Communication
Personal Area Network (PAN): Bluetooth RF
communication (IEEE 802.15.1), 2.4 GHz
ISM band, 1mW
Wireless Local Area Network (WLAN):
Wi-Fi (IEEE 802.11b), 2.4 GHz ISM band,
50mW
Wireless Wide Area Network (WWAN):
Data-only GPRS compatible dual-band for
USA, 850/1900 MHz, 0.6W/1W
Infra-red (IrDA): supports SIR 9.6K/bits to
115.2 Kbps and FIR 4 Mbps data rates. All
PocketPC 2003 IR layers
Wire Interface An Auxiliary Connector support connection
to: USB device, External 12 V DC input,
headset and RS232 Serial interface (RxD,
TxD, CTS, RTS)