User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Introduction
- What is the X-Pad Terminal
- Unpacking
- X-Pad Parts
- Charging the Battery
- Figure 3. Battery Installation and Removal
- Battery Installation and Removal
- 1. Insert the battery, bottom end first, into the battery compartment (see Figure 3).
- 2. Carefully press the battery top downward until it clicks into place. When X-Pad is powered by ...
- 1. Turn the X-Pad off by holding the Power button pressed (see Figure 1), for at least four seconds.
- 2. Press the Release Buttons on the battery sides (see Figure 3) and pull away the battery from t...
- The Universal Office Dock (UOD) Unit
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Storage
- Extending Battery Life
- Using the X-Pad
- Maintaining the X-Pad
- Accessories
- Troubleshooting
- Safety Instructions
- SPECIFICATIONS
24
Keyboard 39 keys: 8 Navigation keys, Scan key, 28
alphanumeric keys and Power On/Off key.
Software controlled backlighting (On/Off
only)
Status Indicator Tricolor LED, Software controlled
Audio Microphone: For Mono sound recording
Speaker: Mono
(Bluetooth audio support as a remote
microphone and speaker)
Beeper: Piezo buzzer with adjustable tones,
maximum sound level is 85 db for audio
notification of proper scans
Imager 2D high-speed LASER (manual scan) sup-
port for common barcode symbologies
including PDF417
Main Battery Two rechargeable Lithium-Ion cells, Nomi-
nal 7.2V, 1800 mAh supporting
Gas gauging for power monitoring
Visible 3 LED bar-graph, switch activated
12 hours typical operation. Fully recharged
within 3 hours in UOD.
Minimum of 300 full discharge/charge
cycles
Built-in safety circuitry.