User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Introduction
- What is the X-Pad Terminal
- Unpacking
- X-Pad Parts
- Charging the Battery
- Figure 3. Battery Installation and Removal
- Battery Installation and Removal
- 1. Insert the battery, bottom end first, into the battery compartment (see Figure 3).
- 2. Carefully press the battery top downward until it clicks into place. When X-Pad is powered by ...
- 1. Turn the X-Pad off by holding the Power button pressed (see Figure 1), for at least four seconds.
- 2. Press the Release Buttons on the battery sides (see Figure 3) and pull away the battery from t...
- The Universal Office Dock (UOD) Unit
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Storage
- Extending Battery Life
- Using the X-Pad
- Maintaining the X-Pad
- Accessories
- Troubleshooting
- Safety Instructions
- SPECIFICATIONS
21
Safety Instructions
Caution – Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation expo-
sure.
X-Pad On-board Aircraft
Always remove the battery from the X-Pad when shipped via air. Any use
of the X-Pad must be in accordance with applicable regulations per airline
crew instructions.
Battery Disposal
Batteries must be recycled or disposed of properly in accordance with local
requirements. Recycling facilities may not exist in all areas. Please contact
your local environmental agency for more information regarding proper
disposal.
To Prevent Injury Or Burns
• USE ONLY SPECIFIED BATTERIES AND CHARGERS
• DO NOT DISPOSE OF ANY BATTERIES IN FIRE, AS THEY MAY EXPLODE!
• DO NOT PUNCTURE OR ALLOW METAL TO CONTACT THE BATTERY TERMINALS
• DO NOT DISPOSE OF IN WATER
• DO NOT DISASSEMBLE
• DO NOT STORE ABOVE 140°F (60°C) OR BELOW - 4°F (-20°C)
Laser Safety
Battery Warnings and Disposal