User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Introduction
- What is the X-Pad Terminal
- Unpacking
- X-Pad Parts
- Charging the Battery
- Figure 3. Battery Installation and Removal
- Battery Installation and Removal
- 1. Insert the battery, bottom end first, into the battery compartment (see Figure 3).
- 2. Carefully press the battery top downward until it clicks into place. When X-Pad is powered by ...
- 1. Turn the X-Pad off by holding the Power button pressed (see Figure 1), for at least four seconds.
- 2. Press the Release Buttons on the battery sides (see Figure 3) and pull away the battery from t...
- The Universal Office Dock (UOD) Unit
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Storage
- Extending Battery Life
- Using the X-Pad
- Maintaining the X-Pad
- Accessories
- Troubleshooting
- Safety Instructions
- SPECIFICATIONS
20
Incomplete or no
data transmis-
sion between X-
Pad and UOD
Communication soft-
ware was incorrectly
installed or config-
ured
Refer to the UOD user manual or
see your system administrator
IrDA communication
window is obscured
Make sure that the IrDA window
of the X-Pad is clean and has a
clear line of sight with the IrDA
window of the UOD
Table 4: Troubleshooting the X-Pad
Problem Cause Solution