User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Introduction
- What is the X-Pad Terminal
- Unpacking
- X-Pad Parts
- Charging the Battery
- Figure 3. Battery Installation and Removal
- Battery Installation and Removal
- 1. Insert the battery, bottom end first, into the battery compartment (see Figure 3).
- 2. Carefully press the battery top downward until it clicks into place. When X-Pad is powered by ...
- 1. Turn the X-Pad off by holding the Power button pressed (see Figure 1), for at least four seconds.
- 2. Press the Release Buttons on the battery sides (see Figure 3) and pull away the battery from t...
- The Universal Office Dock (UOD) Unit
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Storage
- Extending Battery Life
- Using the X-Pad
- Maintaining the X-Pad
- Accessories
- Troubleshooting
- Safety Instructions
- SPECIFICATIONS
14
Action Keys
Table 2 describes the action keys combinations.
Scanning with the X-Pad
The X-Pad hand held terminal enables to decode many barcode symbolo-
gies and capture images in dim lighting conditions.
The terminal features a high-resolution digital imager for omni-directional
and auto-discrimination reading and decoding of linear barcodes, stacked
linear (PDF417) and 2D matrix codes. The imager functions like a digital
camera for either greyscale or black and white pictures.
Table 2: Action Keys Combinations
Action Key Combination
Warm Reset (see also “Reset-
ting the X-Pad”)
H + CLR + GO
Lower Case to Upper Case Let-
ters (default is lower case)
SHIFT + any alphabet key
Audio Recording SHIFT + SP + R
Audio Volume Increase: SHIFT +SP + UP
Decrease: SHIFT + SP + DOWN
Touch Screen Calibration SHIFT + SP + C
Display Illumination Intensity Increase: SHIFT + UP
Decrease: SHIFT + DOWN
Keyboard Back light Intensity Increase: SHIFT + PAGE UP
Decrease: SHIFT + PAGE DOWN
Virtual Keyboard Open/Close: SHIFT + SCAN + SP
PocketPC 2003 Menu SP + SCAN