User's Manual

6
Charging the Battery
The battery is shipped from the fac-
tory uncharged and not installed.
Charge the battery before using the
PowerPad for the first time.
Battery Installation and
Removal
Important Note: The PowerPad
enables you to replace batteries with-
out losing information stored in its
memory. To avoid losing information
stored in the memory, a charged bat-
tery must be installed within 8 hours
after removing the empty battery.
Do not remove battery while the
LED indicator of the PowerPad
shows red.
To install the battery:
1. Insert the battery, bottom end
first, into the battery compart-
ment (see Figure 3).
2. Carefully press the battery top
downward until it clicks into place. When PowerPad is pow-
ered by battery installation for the first time, see note in “Turn-
ing On the PowerPad” on page 11.
To remove the battery:
1. Turn the PowerPad off by holding the Power button pressed
(see Figure 1), for at least four seconds.
2. Press the Release Buttons
on the battery sides (see Figure 3)
and pull the away battery from the PowerPad.
Figure 3. Battery Installation
and Removal
Release
Buttons