Owner's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Introduction
- What is the PowerPad Terminal
- Unpacking
- Charging the Battery
- Figure 3. Battery Installation and Removal
- Battery Installation and Removal
- 1. Insert the battery, bottom end first, into the battery compartment (see Figure 3).
- 2. Carefully press the battery top downward until it clicks into place. When PowerPad is powered ...
- 1. Turn the PowerPad off by holding the Power button pressed (see Figure 1), for at least four se...
- 2. Press the Release Buttons on the battery sides (see Figure 3) and pull the away battery from t...
- The Universal Office Dock (UOD) Unit
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Storage
- Extending Battery Life
- Using the PowerPad
- Maintaining the PowerPad
- Accessories
- Troubleshooting
- Safety Instructions
- SPECIFICATIONS
21
Safety Instructions
• DANGER - LASER LIGHT WHEN OPEN, AVOID DIRECT
EYE EXPOSURE
• CAUTION - LASER LIGHT - DO NOT STARE INTO BEAM
• CLASS II LASER PRODUCT, 650 nm LASER, 0.9 mW
MAX. OUTPUT, COMPLIES WITH 21 CFR 1040.10 &
1040.11, IEC60825-1:1993 + A1:1997 + A2: 2001
• Do not aim the beam at a human eye
• Press the "SCAN" button only when the aperture is aimed at
the barcode
• CAUTION - Use of controls or adjustments or performance of
procedures other than those specified herein may result in haz-
ardous radiation exposure
PowerPad On-board Aircraft
Always remove the battery from the PowerPad when shipped via
air. Any use of the PowerPad must be in accordance with applica-
ble regulations per airline crew instructions.
Battery Disposal
Batteries must be recycled or disposed of properly in accordance
with local requirements. Recycling facilities may not exist in all
areas. Please contact your local environmental agency for more
information regarding proper disposal.
Laser Safety
Battery Warnings and Disposal