Owner's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Introduction
- What is the PowerPad Terminal
- Unpacking
- Charging the Battery
- Figure 3. Battery Installation and Removal
- Battery Installation and Removal
- 1. Insert the battery, bottom end first, into the battery compartment (see Figure 3).
- 2. Carefully press the battery top downward until it clicks into place. When PowerPad is powered ...
- 1. Turn the PowerPad off by holding the Power button pressed (see Figure 1), for at least four se...
- 2. Press the Release Buttons on the battery sides (see Figure 3) and pull the away battery from t...
- The Universal Office Dock (UOD) Unit
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Storage
- Extending Battery Life
- Using the PowerPad
- Maintaining the PowerPad
- Accessories
- Troubleshooting
- Safety Instructions
- SPECIFICATIONS
20
PowerPad
does not
respond
Problem in Power-
Pad operating sys-
tem or
communication
network
Execute Warm reset by
simultaneously pressing soft
keys H+CLR+GO for at least
one second; the PowerPad
should function again
If PowerPad still does not
respond, perform Cold rest
(see “Resetting the Power-
Pad” on page 16). The opera-
tion system will reboot after
about 30 seconds
Incomplete or
no data trans-
mission
between Pow-
erPad and
UOD
Communication
software was incor-
rectly installed or
configured
Refer to the UOD user man-
ual or see your system
administrator
IrDA communica-
tion window is
obscured
Make sure that the IrDA win-
dow of the PowerPad is clean
and has a clear line of sight
with the IrDA window of the
UOD
Table 4: Troubleshooting the PowerPad
Problem Cause Solution