Owner's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Introduction
- What is the PowerPad Terminal
- Unpacking
- Charging the Battery
- Figure 3. Battery Installation and Removal
- Battery Installation and Removal
- 1. Insert the battery, bottom end first, into the battery compartment (see Figure 3).
- 2. Carefully press the battery top downward until it clicks into place. When PowerPad is powered ...
- 1. Turn the PowerPad off by holding the Power button pressed (see Figure 1), for at least four se...
- 2. Press the Release Buttons on the battery sides (see Figure 3) and pull the away battery from t...
- The Universal Office Dock (UOD) Unit
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Storage
- Extending Battery Life
- Using the PowerPad
- Maintaining the PowerPad
- Accessories
- Troubleshooting
- Safety Instructions
- SPECIFICATIONS
16
Resetting the PowerPad
You may need to reset your Pow-
erPad; for example, you may
reset due to communication cut-
off, or if the operating system
stops responding.
If your PowerPad stops respond-
ing, do the following actions:
Warm Reset
Important Note: When the
PowerPad is warm reset, all
recorded information remains
stored in memory.
Simultaneously, press keys H + CLR + GO (see Figure 9); the
PowerPad will function again.
If your PowerPad still does not respond, perform “Cold Reset”:
Figure 9. Warm Reset