Owner's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Introduction
- What is the PowerPad Terminal
- Unpacking
- Charging the Battery
- Figure 3. Battery Installation and Removal
- Battery Installation and Removal
- 1. Insert the battery, bottom end first, into the battery compartment (see Figure 3).
- 2. Carefully press the battery top downward until it clicks into place. When PowerPad is powered ...
- 1. Turn the PowerPad off by holding the Power button pressed (see Figure 1), for at least four se...
- 2. Press the Release Buttons on the battery sides (see Figure 3) and pull the away battery from t...
- The Universal Office Dock (UOD) Unit
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Storage
- Extending Battery Life
- Using the PowerPad
- Maintaining the PowerPad
- Accessories
- Troubleshooting
- Safety Instructions
- SPECIFICATIONS
15
Scanning with the
PowerPad
The PowerPad has an inte-
grated Laser scanner which
gathers data by scanning
barcodes. The PowerPad is
equipped with a SCAN
trigger button, designed for
both left-handed and right-
handed users (see Figure
8). The button is located at
the center of the terminal
navigation key panel.
To scan 1D (one dimen-
sional) barcodes; aim the
scanner at the barcode and
press the SCAN trigger
button (see Figure 8). To
scan 2D barcodes; aim the
scanner at the barcode top,
press the SCAN trigger
button and move the beam
vertically down on the bar-
code (see Figure 8). Ensure
that the red scan beam cov-
ers the entire barcode area.
A beep sound indicates a
successful decode.
LASER LIGHT
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
LUMIERE LASER
NE PAS REGARDER LE RAYON FIXEMENT
PRODUIT LASER DE CLASSE 2
18° Scan
Angle
SCAN Trigger Button
Figure 8. Scanning with the PowerPad
1D Barcode Scanning
2D Barcode Scanning