Owner's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Introduction
- What is the PowerPad Terminal
- Unpacking
- Charging the Battery
- Figure 3. Battery Installation and Removal
- Battery Installation and Removal
- 1. Insert the battery, bottom end first, into the battery compartment (see Figure 3).
- 2. Carefully press the battery top downward until it clicks into place. When PowerPad is powered ...
- 1. Turn the PowerPad off by holding the Power button pressed (see Figure 1), for at least four se...
- 2. Press the Release Buttons on the battery sides (see Figure 3) and pull the away battery from t...
- The Universal Office Dock (UOD) Unit
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Storage
- Extending Battery Life
- Using the PowerPad
- Maintaining the PowerPad
- Accessories
- Troubleshooting
- Safety Instructions
- SPECIFICATIONS
11
Using the PowerPad
Turning On the PowerPad
Press the Power button to turn On the PowerPad (see Figure 7) -
when turned On, the last displayed screen will be shown again.
Note: The PowerPad powers On immediately when the battery is
installed for the first time or after Cold Reset (see page 16) - the
Motorola logo will show for about 30 seconds and you will be
required to follow on-screen alignment (calibration) instructions.
Turning Off the PowerPad
When the PowerPad is On, hold the Power button pressed (see Fig-
ure 7) for at least four seconds.
When the battery is removed (see “Battery Installation and
Removal”) from the PowerPad during operation, the PowerPad
turns off automatically. To resume operation, press the Power but-
ton.
Suspend Mode
When the PowerPad is On, press the Power button (see Figure 7) to
enter Suspend mode. During Suspend mode the display turns off
and the LED indicator slowly blinks green. To resume operation,
press the Power button again.
In Suspend mode, battery power is saved by turning off the display
and computer sections of the PowerPad. During Suspend mode, the
GPRS and Bluetooth radios continue to operate. When the Power-
Pad resumes operation, it returns to the screen shown prior to Sus-
pend mode.
Use Suspend mode as often as possible to save battery power.
LED Indicator Function
LED shows red - do not remove battery.