User Card

6
Installing the Battery
The battery is shipped from
the factory uncharged and
not installed. Charge the bat-
tery before using the Power-
pad for the first time.
To install the battery:
1. Insert the battery, bottom
end first, into the battery
compartment (see Figure
3).
2. Carefully press the bat-
tery top downward until
it clicks into place.
Removing the Battery
Important Note: The Powerpad
enables you to replace batteries with-
out losing information stored in its
memory. To avoid losing information
stored in the memory, a charged bat-
tery must be installed within 8 hours
after removing the empty battery.
1. Turn the Powerpad off by holding
the Power button pressed (see Fig-
ure 1) for at least four seconds.
2. Press the Release Buttons
on the
battery sides (see Figure 4) and
remove the battery away from the Powerpad.
Figure 3. Battery Installation
Figure 4. Battery Removal