User's Manual

19
HDT 600
stopped
responding.
Problem in HDT
600 operating sys-
tem or communica-
tion network.
Simultaneously press soft
keys 1, 2 and the Power but-
ton for at least 5 seconds; the
HDT 600 should function
again.
If still does not respond,
simultaneously press soft
keys 2, 3 and 4 to restart your
HDT 600. The operation sys-
tem will reboot for about a
minute.
Incomplete or
no data trans-
mission
between HDT
600 and PC.
HDT 600 is not
locked in Cradle.
Lock the HDT 600 properly
in Cradle (See that the red
LED is on).
Cradle contacts are
not clean.
Clean contacts and remove
dust and objects from within
the Cradle.
Bad RS232 cable. Replace the RS232 cable.
Communication
software was incor-
rectly installed or
configured.
See your System Administra-
tor.
Table 2: Troubleshooting
Problem Cause Solution