User's Guide

VEHICULAR CHARGER PMLN6716_
English
39
Troubleshooting
If There is Fast Flash Red Indication:
1 Confirm the battery being used with the WRSM is listed in Table 5.1
and is good in condition.
2 Remove the battery and restart the Vehicular Charger.
3 If the symptom persist, please send the Vehicular Charger to the
nearest Service Center for further verification.
If There is No LED Indication:
1 Check that the WRSM with battery or the battery is inserted
correctly in the pocket.
2 Make sure that the CLA adapter is plugged into a CLA power
source and the LED on the CLA adapter is on.
3 Confirm that the battery being used with the WRSM is listed in
Table 5.1 .
Fast Flash Red
Battery under voltage recovery time out
OR
Loss of charge current control
OR
Excessive power supply voltage
OR
Fault connection happened
– DO NOT charge battery
Off
If battery is inserted into a successfully powered
up charger, battery may have bad contact with
charger
Table 5.3: Charging Status (Continued)