User's Manual
Table Of Contents
- Contents
- Product Safety
- Introduction
- FCC Licensing Information
- Batteries and Chargers Safety Information
- Radio Overview
- Parts Of The Radio
- Battery Features
- About the Li-Ion Battery
- Battery Recycling and Disposal
- Installing the Lithium-Ion (Li-Ion) Battery
- Removing the Lithium-Ion (Li-Ion) Battery
- Holster
- Power Supply, Adaptor and Drop-in Tray Charger
- Battery Life Information
- Charging the Battery
- Drop-in Tray Charger Charge Status Indicators
- Drop-in Tray Charger Battery State of Charge Indications
- Estimated Charging Time
- Multi-Unit Charger Charge Status Indicators
- Multi-Unit Charger Battery State of Charge Indications
- Getting Started
- Advanced Radio Configuration
- Customer Programming Software (CPS)
- Troubleshooting
- Use and Care
- Motorola Limited Warranty for the United States and Canada
- Accessories
English
44
CUSTOMER PROGRAMMING
SOFTWARE (CPS)
2. Power the Target radio following the sequence
below:
• Press the PTT button and the (-) button
simultaneously while turning the radio
ON.
• Wait for 3 seconds before releasing the
buttons until the audible tone and voice
announcement “Clone Mode Serial” are
heard.
3. On the Source radio, press and release the (+)
button to start the Wireless PIN cloning. The
radio generates an audible tone.
4. After cloning is completed, the Source radio will
announce either “successful” (cloning is
successful) or “fail” (cloning has failed).
5. On the Target radio, the radio receives the PIN
information. The Target radio will announce
either “successful” (cloning is successful) or
“fail” (cloning has failed).
CPS and Cloning Cables (Optional
Accessory)
• Both CPS and Cloning Cables are made to work
with DLR Series radios.
• CPS cable programs DLR Series radios. Make
sure the cable switch is in “CPS Digital” position
and the USB converter provided in the CPS cable
kit is attached to the cable.
• Cloning cable allows you to clone DLR Series
radios. Make sure the switch is in “Cloning”
position.