User's Manual

English
42
CUSTOMER PROGRAMMING
SOFTWARE (CPS)
CLONING RADIOS
You can clone DLR Series radio profiles from
one Source radio to a Target radio by using any
one of these 4 methods:
• Using a Multi Unit Charger (MUC- optional
accessory),
• Using two Single Unit Chargers (SUC) and a
Radio-to-Radio cloning cable (optional
accessory),
• the CPS (free software download), and
• Wireless PIN cloning.
Cloning with a Multi-Unit Charger (MUC)
To clone radios using the MUC, there must be
at least two radios:
• a Source radio (radio which profiles will be cloned
or copied from) and
• a Target radio (the radio which profile will be
cloned from the source radio.)
The Source radio has to be in Pocket 1, 4, 7 or
10 while the Target radio has to be in Pocket 2,
5, 8 or 11, matching in the MUCs pockets by
pairs as follows:
• 1 and 2,
• 4 and 5,
• 7 and 8, or
• 10 and 11.
When cloning, the MUC does not need to be
plugged into a power source, but ALL radios
require charged batteries.
1. Turn ON the Target radio and place it into one of
the MUC Target Pockets
2. Power the Source radio following the sequence
below:
Pocket 1
Pocket 2
“CLONE” symbol
Pocket 11Pocket 10
“CLONE” symbol