User's Manual
Table Of Contents
- Contents
- Product Safety
- Introduction
- FCC Licensing Information
- Batteries and Chargers Safety Information
- Radio Overview
- Parts Of The Radio
- Battery Features
- About the Li-Ion Battery
- Battery Recycling and Disposal
- Installing the Lithium-Ion (Li-Ion) Battery
- Removing the Lithium-Ion (Li-Ion) Battery
- Holster
- Power Supply, Adaptor and Drop-in Tray Charger
- Battery Life Information
- Charging the Battery
- Drop-in Tray Charger Charge Status Indicators
- Drop-in Tray Charger Battery State of Charge Indications
- Estimated Charging Time
- Multi-Unit Charger Charge Status Indicators
- Multi-Unit Charger Battery State of Charge Indications
- Getting Started
- Advanced Radio Configuration
- Customer Programming Software (CPS)
- Troubleshooting
- Use and Care
- Motorola Limited Warranty for the United States and Canada
- Accessories
English
34
GETTING STARTED
There will be tone reminders to alert you that
you're still in queue (similar to Private Reply).
Note: You will not be able to talk to the person
privately UNTIL the person on the other end
finish the transmission.
A call reminder tone sounds after 1 minute of
being in queue followed by a reminder 4
minutes after. No other reminder is heard
afterwards, but you remain in queue until the
mode is physically exited.
Note: This assumes that the radio ID to be called
in private is already stored and is always on
Private Direct Call.
While queued for Private Direct Call – press
and hold the PTT button to speak directly to the
stored Radio ID.
• If successful: During Private Direct Call
Transmitting, Programmable Top button becomes
solid green and the Tx/Rx Indicator LED stays
solid red and you will hear a distinct Private Talk
permit tone. Begin speaking to the private
Press button to queue up
for Private Direct Call
Programmable Top Button
LED blinks when queued up