User's Manual
Table Of Contents
- Contents
- Product Safety
- Introduction
- FCC Licensing Information
- Batteries and Chargers Safety Information
- Radio Overview
- Parts Of The Radio
- Battery Features
- About the Li-Ion Battery
- Battery Recycling and Disposal
- Installing the Lithium-Ion (Li-Ion) Battery
- Removing the Lithium-Ion (Li-Ion) Battery
- Holster
- Power Supply, Adaptor and Drop-in Tray Charger
- Battery Life Information
- Charging the Battery
- Drop-in Tray Charger Charge Status Indicators
- Drop-in Tray Charger Battery State of Charge Indications
- Estimated Charging Time
- Multi-Unit Charger Charge Status Indicators
- Multi-Unit Charger Battery State of Charge Indications
- Getting Started
- Advanced Radio Configuration
- Customer Programming Software (CPS)
- Troubleshooting
- Use and Care
- Motorola Limited Warranty for the United States and Canada
- Accessories
English
23
RADIO OVERVIEW
Charging a Radio and Battery using
a Multi Unit-Charger - MUC (Optional
Accessory)
The Multi-Unit Charger (MUC) allows drop-in
charging of up to 12 radios or up to 6 radios
and 6 stand-alone batteries. Batteries can be
charged with the radios or removed and placed
in the MUC separately. Each of the 12 charging
pockets can hold a radio (with or without the
Holster) or battery, but not both.
1. Place the Multi-Unit Charger on a flat surface.
2. Insert the power cord plug into the MUC’s dual
pin connector at the bottom of the MUC.
3. Plug the power cord into an AC outlet.
4. Turn the radio OFF.
5. Insert the radio or battery into the charging
pocket with the radio or battery facing away
from the contacts.
Note:
• This Multi-Unit Charger clones up to 2 radios (2
Source radios and 2 Target radios). Refer to
“Cloning with a Multi-Unit Charger (MUC)” on
page 42 for more information.
• More information on the Multi-Unit Charger’s
operation is available in the Instruction Sheets
provided with the MUC. For more information on
the parts and their part numbers, refer to Chapter
“Accessories” on page 57.