User Manual

NOTICE:
Depending on languages installed on the radio, some characters in names of devices
might not be displayed properly.
Radio-initiated automatic reconnection with remote Bluetooth devices cannot be
guaranteed to be successful in 100% of cases when several devices need to reconnect
at the same time, due to the fundamental nature of Bluetooth. In case the reconnection
fails after a power cycle (power off and power on of the radio), reconnect the device
manually.
Managing Devices
Procedure:
1 From the home screen, press the MENU key.
2 Select Bluetooth → Devices.
3 Highlight the required device and press the MENU key.
• Name – shows the name of the device (up to 32 characters long). The name is editable by
the user only if it has not been pre-set by the service provider.
• Type – displays the device type. This menu item cannot be configured.
• Access – defines how the radio behaves during a reconnection attempt after losing
connection to this device:
• Automatic – the radio connects with the device automatically.
NOTICE: On some headsets, you may have to press the "Call" button to trigger
reconnection.
• Ask – the radio asks you for confirmation before connecting with the device.
• Manual – you need to connect with the device manually each time.
• Never – the radio never connects with the device.
• Delete – deletes the device from the paired devices lists.
Disconnecting All Devices
When and where to use: To disconnect all remote devices connected to your radio.
Procedure:
1 From the home screen, press the MENU key.
2 Select Bluetooth → Disconnect All.
All devices are disconnected.
NOTICE: To disconnect only one device, from the home screen select MENU → Bluetooth →
Devices, highlight the required device, and press Disconnect.
Indoor Location
When and where to use: Indoor Location can be used to keep track of radio users location while
indoors. When Indoor Location is activated, the radio is in a limited discoverable mode. Dedicated
Chapter 5: Main Menu
82 Send Feedback