User's Manual
Table Of Contents
- APX Vehicular Adapter (VA) System Compatibility Matrix
- ASTRO™ APX™ Vehicular Adapter (APX VA) RF Energy Exposure and Product Safety
- RF Energy Exposure Awareness and Control Information, and Operational Instructions for Federal Communication Commission (FCC) Occupational Use Requirements
- Federal Communication Commission (FCC) Regulations
- Compliance with RF Exposure Standard
- RF Exposure Compliance and Control Guidelines and Operating Instructions
- Mobile Antenna Installation Guidelines
- Approved Accessories
- Additional Information
- Compliance and Control Guidelines and Operating Instructions for Mobile Two-Way Radios Installed as Fixed Site Control Stations
- Compliance and Control Guidelines and Operating Instructions for Mobile Two-Way Radios Installed on Maritime Vessels
- Electromagnetic Interference or Compatibility
- Driver Safety
- Acoustic Safety
- Operational Warnings
- Installation Instructions
- Introduction
- Installation Requirements for Compliance with RF Energy Exposure Safety Standards
- Installation Planning
- Console Installation
- Antenna Installation
- Console Cabling
- LED Surveillance Configuration (Option Wiring – User Configurable)
- Installation Verification
- Maintenance
- Operational Warnings
- Operational Cautions
- Efficient System Operation
- User Guide
16
3. Insert the Allen-screws provided through the trunnion bracket and screw
them into the console. Since the console may have to be removed later to
connect the cables, do not tighten the screws at this time.
Figure 1: Console Installation Detail
Legend:
1. No. 10-12 x 1-1/4” Self-Drilling,
Self-Tapping Screw (Quantity 4)
2. M5 x 18mm Screws (Quantity 2)
Cut-Away of Dash
0.125” (0.3175 cm) Dia. Holes
Trunnion Bracket (Optional)
Console
1
Plastic
Guides
Groove
2
Trunnion Bracket (Optional)
2
1
Dash
Mount
Floor
Mount
or
MN000350A02.book Page 16 Tuesday, December 2, 2014 3:01 PM