User's Manual

95
MOTOtalk
TM
make and receive a
code call
1 Press and hold the PTT button. MT Transmit
appears on the first line of display. Begin
speaking after your handset emits the
MOTOtalk tone.
2 Release the PTT button to listen.
The tone emitted from your handset when
using MOTOtalk is 4 beeps and sounds
different from the standard tone heard with
on-network Private and group calls.
If you receive an error message:
• There may be no parties on your
channel or code.
• You are out of range.
When you receive a code call using
MOTOtalk,
MT Receive appears on the first line
of the display.
Note: An incoming MOTOtalk call can
be terminated at any time by
pressing {
.
set to receive all
You can set your handset to receive
MOTOtalk transmissions from any handset
that is set to the same channel, regardless of
the code (1-15), by setting the code to
Receive
All
. When you receive transmissions with the
code set to
Receive All , the display changes
from
Receive All to the code on which the
transmission was received.
Tip: You can reply to an incoming call within 6
seconds after hearing the short ending beep
by pressing the PTT button.
Note: You cannot initiate a code call when the
code is set to
Receive All . If you press the PTT
button with the code set to
Receive All , you will
receive an error message.