User's Manual

34
Contacts
2 Select Filter.
3 Set this option to Show Prvt/Grp/Hub.
To set Contacts to show all entries:
1 From the Contacts list, press m.
2 Select Filter.
3 Set this option to Show All.
Creating Entries
A number or address and a Contacts type are
required for all Contacts entries. Other information
is optional. You may enter the information in any
order by scrolling through the entry details.
After you have entered the number or address,
Contacts type, and any other information you want,
you can press A under Done to save the entry to
Contacts.
To cancel a Contacts entry at any time press, e
to return to the idle screen.
To create a Contacts entry:
1 To access the entry details screen:
Select Contacts > [New Contact]. -or-
From the Contacts list, press m. Select New
Contact.
2 Ifyouwanttoassignanametotheentry:
Select Name.
Enter the name. When you are finished, press
O.
Tip: Press A under Browse to select a name
already in Contacts.
3 Ifyouwanttoassignaringtonetothename:
Select Ringer.
Selecttheringtoneyouwanttoassign.
4 ToassignaContactstypetothenumberor
address being stored:
Select the Contacts type field.
Select the Contacts type you want to assign.
Note: For information about creating SDG lists,
see “Creating SDG Lists in Contacts” on
page 52.
5 To store a number or address:
Select the # field (or ID for an email address, or
IP for an IP address).
Enter the number or address. For phone
numbers, use the 10-digit format. For email
addresses, see “Entering Text” on page 61.
Tip: Press A under Browse to select a number
or address from Contacts, the recent calls
list, or Memo.