User's Manual

59
STAT-ALERT
FEATURES
Note: The green ßashing LED, alert tone, and
ßashing annunciator will continue until the Call
Alert is acknowledged (press PTT, or press and
release the monitor button).
Making a Call Alert
There are three phases in making a call alert,
namely
¥ initiating a call alert,
¥ entering the radio ID number that you wish to
page, and
¥ sending the call alert.
Initiating a Call Alert
Note: The same list is shared by both Call Alert
and Select Call features.
¥ If your radio has been so programmed, you
can press the page button for quick access to
the Call Alert feature. This will take you directly
to step 3.
Entering the Radio ID Number that you
wish to Page
The procedure for entering the Radio ID Number is
exactly the same as the process outlined in the
Select Call section. Please refer to Entering the
Desired Radio ID Number on page 57.
Sending the Call Alert
If the page is unsuccessful
5. The display shows the
current mode. The audi-
ble alert, LED and call
received annunciator
turns off.
6. The ID number of the radio that paged you is
stored as Òthe last ID number received.Ó
1. Press / until PAGE is
displayed.
2. Press l (the softkey below PAGE).
FIRE DEPT
PAGE
PHON
VIEW
3. The display shows the
last ID number transmit-
ted or received.
4. Press the PTT switch to transmit the ID num-
ber.
5a. If the called radio fails to acknowledge the
alert, a low-pitched alert tone sounds and the
display changes to ÒNO ACKNOWLEDGEÓ.
ID: 2350
ATS2500
.
book Page 59 Monday
,
December 18
,
2000 7:39 PM