User's Manual

43
TELEPHONE
OPERATION
Sending the Telephone Number
Sending the telephone number using the keypad
Sending the telephone number using a Number on
the Telephone List
3. Your radio attempts to access the telephone
system.
4. If you connect successfully, you will hear a dial
tone.
5. The display will show the
last number dialed.
6a. The number can now be entered from the
keypad, using any of the numeric (0 Ð 9) keys,
and the Ò*Ó and Ò#Ó keys. The cursor ßashes to
indicate the location of the next digit to be
entered. A pause can be entered in the tele-
phone number by Þrst pressing the Ò*Ó key,
then the Ò#Ó key (Buffered dial only - The
pause will be shown on the display as a ÒPÓ).
6b. If your radio is programmed for Òlive dial,Ó each
digit is sent out as its key is pressed.
ÑorÑ
If your radio is programmed for Òbuffered dial,Ó
each digit is temporarily stored as you enter
them. After entering the number, press the
PTT switch to send out the number.
5551135
6c. The telephone number will be sent out; you
will hear tones as they are sent. If you hear a
busy signal, go to step 8 for hang-up proce-
dure.
6a. Press , or /, to enter the telephone
list. / takes you forward to the next mem-
ber of the list; , takes you backwards to
the previous member of the list.
6b. Stop at the member you wish to call.
6c. The display alternates
between showing the
memberÕs name and
telephone number.
Alternates between
and
6d. Press the PTT button.
6e. The telephone number
will be sent out; you will
hear tones as they are
sent.
6f. If you hear a busy signal, go to step 8 for
hang-up procedure.
POLICE DEPT
5556445
POLICE DEPT
ATS2500
.
book Page 43 Monday
,
December 18
,
2000 7:39 PM