User's Manual

SCAN

Scan Modes

When programming the scan list, each member can

be given one of several scan modes. The following

table lists the scan mode cycle activated by

subsequent presses of the select key.

Note: There can only be ONE Priority 1 member

and ONE Priority 2 member in a scan list. Thus,

if there is already a Priority 1 member in the

scan list, changing another memberÕs mode to

Priority 1, would automatically cause the previ-

ous memberÕs mode to be changed to a Scan

Member. This same behavior is also seen when

programming the Priority 2 member.

Initial Scan

Mode of Member

Number of Times the Select Key is Pressed

1 2 3 4

Priority 2*

Priority 1* Non Scan Member Scan Member Priority 2*

Priority 1*

Non Scan Member Scan Member Priority 2* Priority 1*

Non Scan

Member

Scan Member Priority 2* Priority 1* Non Scan Member

Scan Member

Priority 2* Priority 1* Non Scan Member Scan Member

* Priority options are only available if enabled.

ATS2500

book Page 38 Monday

December 18

2000 7:39 PM