User's Manual
Table Of Contents
- Contents
- Introduction 1
- Getting Started 2
- Making Calls 17
- Call Alerts 22
- Recent Calls 24
- Entering Text 26
- Contacts 29
- Memo 35
- Advanced Calling Features 36
- Boost MobileTM Phone Services 41
- Ring Tones 43
- Message Center 46
- Receiving Messages 47
- Voice Mail Messages 49
- Boost Mobile Voice Mail 50
- SMS and Boost MobileTM Text and Numeric Messages 57
- Boost Mobile Wireless Web Services 61
- Call Forwarding 63
- Customizing Your Phone 65
- GPS Enabled 70
- Boost Mobile Customer Care 79
- Understanding Status Messages 80
- Boost MobileTM Terms and Conditions of Prepaid Service 82
- Safety and General Information 92
- MOTOROLA LIMITED WARRANTY 100
- Patent and Trademark Information 104
- Index 105
- DECLARATION OF CONFORMITY
- Introduction
- Getting Started
- Making Calls
- Call Alerts
- Recent Calls
- Entering Text
- Contacts
- Memo
- Advanced Calling Features
- Boost MobileTM Phone Services
- Ring Tones
- Message Center
- Receiving Messages
- Voice Mail Messages
- Boost Mobile Voice Mail
- SMS and Boost MobileTM Text and Numeric Messages
- Boost Mobile Wireless Web Services
- Call Forwarding
- Customizing Your Phone
- GPS Enabled
- Boost Mobile Customer Care
- Understanding Status Messages
- Boost MobileTM Terms and Conditions of Prepaid Service
- Safety and General Information
- MOTOROLA LIMITED WARRANTY
- Patent and Trademark Information
- Index
77
Using GPS with Map Software
Note: Because your phone is continuously
determining your location, using the GPS
feature of your phone with map software
uses the phone’s battery power quickly.
Software Compatibility
Your phone sends location information to your
laptop or other device using the standard National
Marine Electronics Association (NMEA) format.
Your phone supports output messages in
NMEA-0183 format and supports the following
NMEA-0183 sentences: GGA, GLL, GSA, GSV,
RMC, and VTG.
The map software running on your laptop or other
device must support NMEA 3.0.
Getting Started
To connect your phone to your laptop or other
device:
1 With the phone’s display facing up, insert the
data cable’s connector into the accessory
connector, until you hear a click.
2 InsertthedataplugintotheCOMportofyour
laptop or other device.
Make sure no other application is using the COM
port selected.
Make sure the COM port settings of your laptop or
other device are set to the following:
• Bits per second: 4800
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: Hardware