User's Manual
Table Of Contents
- Motorola
- iDEN®
- Digital Multi-Service Data-Capable Phone
- i30sx Phone User’s Guide
- Table of Contents
- Introduction
- Getting Started
- Display Essentials
- Phonebook
- Digital Cellular
- Messages
- Private Calls
- Memo
- Customizing the i30sx phone
- Accessories
- Other Important Information
- Safety and General Information
- RF Operational Characteristics
- PORTABLE RADIO PRODUCT OPERATION AND EME EXPOSURE
- Electro Magnetic Interference/Compatibility
- Medical Devices
- Operational Warnings
- Operational Cautions
- Accessory Safety Information
- Limited Warranty Motorola Communication Products
- Limited Warranty Motorola Communication Products (International)
- Patent and Trademark Information
- A
- B
- C
- D
- E
- F
- G
- I
- K
- L
- M
- N
- P
- R
- S
- T
- U
- V
- W
105
Settings
Feature Reset
Feature Reset returns all your phone’s settings to their original defaults. To use
this feature, you must contact your service provider to receive your phone’s
Unlock code.
Setting Baud Rate
You can set your phone’s baud rate from the Initial Setup screen. Scroll to the
Baud Rate option and then choose the baud rate you want, or choose Auto to
set your phone to automatically choose the appropriate baud rate.
Setting TTY Mode
TTY Setup enables you to set your options for using your phone with a
teletypewriter (TTY) device. By default, your phone is set to function with a
TTY device in TTY mode.
Your phone supports the following TTY modes:
• TTY — for calls in which you type and read text on your TTY device.
• VCO (Voice-Carry-Over) — for calls in which you speak into your phone
and read text replies on your TTY device.
• HCO (Hearing-Carry-Over) — for calls in which you type text on your
TTY device on listen to voice replies on your phone’s speaker.
You can set your TTY mode using your phone’s Settings menu at any time, or
by issuing commands from your TTY device while on an active call.
To set your phone’s TTY mode using your phone’s Settings menu:
To set your phone’s TTY mode from your TTY device, issue one of the
following commands while on an active call:
•“VCO please”—to select VCO mode.
1
From the Initial Setup screen, press R to scroll to TTY Setup.
2
Press B under CHANGE.
3
Press S to scroll to the desired TTY mode; Off, TTY, VCO,orHCO.
4
Press B under SELECT.