User's Manual
Table Of Contents
- Contents
- Safety
- Radio Overview
- Getting Started
- Battery Information
- Accessory Information
- Turning Radio On or Off
- Adjusting the Volume
- Selecting a Mode
- Sending a Trunked Call
- Sending a Conventional Call
- Receiving a Trunked or Conventional Call
- Failsoft Operation (Trunked Systems Only)
- Coded Squelch Operation (Conventional Channels Only)
- Smart PTT (Conventional Operation Only)
- Radio Calls (Trunked Operation Only)
- Scan
- Warranty
- Accessories
28
English
GETTING STARTED
Attaching the Side Connector Cover
TURNING RADIO ON OR OFF
Turn the radio on by rotating the volume
control clockwise. The radio goes through a
power-up self check and, if it passes the
check, a good-power-up, high-pitched tone
sounds to indicate that the radio has passed
the self check.
If the radio fails the self check, a bad-power-
up, low-pitched tone will be heard. Turn the
radio off, check the battery, and turn the radio
back on. If the radio still does not pass the self
check, a problem exists in the radio. Contact
your authorized Motorola dealer.
1
Place the loop (attached to the side con-
nector cover) over the antenna; then slide it
downward until it touches the top of the
radio.
2
Insert the tab on the top of the cover into
the slot above the connector.
3 Position the cover over the connector and
align the thumbscrew with the threaded
hole in the radio.
4 Tighten the thumbscrew to hold the cover in
place. Do not overtighten the thumbscrew.
Loop
Slot
Thumbscrew
Antenna
ON OFF