User's Guide

Radio leaves lower priority talkgroup call for higher priority
talkgroup call.
NOTE:
This feature can only be accessed when Talkgroup
Scan feature is enabled.
Priority Monitor feature applies only to members in the
Receive Group List. There are two Priority Talkgroups:
Priority 1 (P1) and Priority 2 (P2). P1 has higher priority
than P2. In Capacity Max system, the radio receives
transmission according to the priority order below:
1 Emergency Call for P1 Talkgroup
2 Emergency Call for P2 Talkgroup
3 Emergency Call for Non-priority Talkgroups in the
Receive Group List
4 All Call
5 P1 Talkgroup Call
6 P2 Talkgroup Call
7 Non-priority Talkgroups in the Receive Group List
NOTE:
This feature is programmed by the system
administrator. Check with your dealer or system
administrator for more information.
5.7.6
Multi-Talkgroup Affiliation
Your radio can be configured for up to seven talkgroups at
a site.
Of the 16 talkgroups in the Receive Group List, up to
seven talkgroups can be assigned as affiliation talkgroups.
The selected talkgroup and the priority talkgroups are
automatically affiliated.
5.7.7
Talkback
The Talkback feature allows you to respond to a
transmission while scanning.
If your radio scans into a call from the selectable group
scan list, and if the PTT button is pressed during
the scanned call, the operation of the radio depends
on whether Talkback was enabled or disabled during
radio programming. Check with your dealer or system
administrator for more information.
Talkback Disabled
The radio leaves the scanned call and attempts to
transmit on the contact for the currently selected
channel position. After the Call Hang Time on the
English
62