User's Guide
Table Of Contents
- Contents
- Supplier's Declaration of Conformity
- Important Safety Information
- Notice to Users (FCC)
- Notice to Users (Industry Canada)
- Software Version
- Intellectual Property and Regulatory Notices
- Computer Software Copyrights
- Radio Care
- Introduction
- Getting Started
- 2.1 Charging the Battery
- 2.2 Attaching the Battery
- 2.3 Attaching the Antenna
- 2.4 Attaching the Carry Holster
- 2.5 Attaching the Universal Connector Cover
- 2.6 Cleaning the Universal Connector Cover
- 2.7 Removing the Universal Connector Cover (Dust Cover)
- 2.8 Turning the Radio On
- 2.9 Turning the Radio Off
- 2.10 Adjusting the Volume
- Radio Controls
- WAVE
- Capacity Max
- 5.1 Push-To-Talk Button
- 5.2 Programmable Buttons
- 5.3 Status Indicators
- 5.4 Registration
- 5.5 Zone and Channel Selections
- 5.6 Calls
- 5.7 Advanced Features
- 5.7.1 Call Queue
- 5.7.2 Priority Call
- 5.7.3 Talkgroup Scan
- 5.7.4 Receive Group List
- 5.7.5 Priority Monitor
- 5.7.6 Multi-Talkgroup Affiliation
- 5.7.7 Talkback
- 5.7.8 Bluetooth®
- 5.7.9 Multi-Site Controls
- 5.7.10 Home Channel Reminder
- 5.7.11 Remote Monitor
- 5.7.12 Call Indicator Settings
- 5.7.13 Call Alert Operation
- 5.7.14 Mute Mode
- 5.7.15 Emergency Operation
- 5.7.16 Text Messaging
- 5.7.17 Privacy
- 5.7.18 Stun/Revive
- 5.7.19 Radio Kill
- 5.7.20 Lone Worker
- 5.7.21 Password Lock
- 5.7.22 Over-the-Air Programming
- 5.7.23 Wi-Fi Operation
- 5.8 Utilities
- 5.8.1 Checking Battery Strength
- 5.8.2 Text-to-Speech
- 5.8.3 Turning the Acoustic Feedback Suppressor Feature On or Off
- 5.8.4 Turning Global Navigation Satellite System On or Off
- 5.8.5 Turning Radio Tones/Alerts On or Off
- 5.8.6 Power Levels
- 5.8.7 Turning Option Board On or Off
- 5.8.8 Turning Voice Announcement On or Off
- 5.8.9 Switching Audio Route between Internal Radio Speaker and Wired Accessory
- 5.8.10 Turning Intelligent Audio On or Off
- 5.8.11 Turning Trill Enhancement On or Off
- Connect Plus
- 6.1 Additional Radio Controls in Connect Plus Mode
- 6.2 Making and Receiving Calls in Connect Plus Mode
• Your radio unmutes and the incoming call sounds
through the speaker.
NOTE:
Recipient users are not allowed to Talkback during
a Broadcast Call. The Talkback Prohibit Tone plays
momentarily if the PTT button is pressed during a
Broadcast Call.
5.6.3
Private Call
A Private Call is a call from an individual radio to another
individual radio.
There are two ways to set up a Private Call.
•
The first call type is called Off Air Call Set-Up (OACSU).
OACSU sets up the call after performing a radio
presence check and completes the call automatically.
• The second type is called Full Off Air Call Set-Up
(FOACSU). FOACSU also sets up the call after
performing a radio presence check. However, FOACSU
calls require user acknowledgment to complete the call
and allows the user to either Accept or Decline the call.
The type of call is configured by the system administrator.
NOTE:
Both the call initiator and recipient are able to
terminate an on-going Private Call by pressing the
programmed Cancel button.
5.6.3.1
Making Private Calls
Your radio must be programmed for you to initiate a Private
Call. If this feature is not enabled, you hear a negative
indicator tone when you initiate the call.
If the target radio is
not available, a short tone sounds.
1 Do one of the following:
• Select a channel with the active subscriber alias
or ID. See Selecting a Call Type on page 44.
• Press the programmed One Touch Access
button.
2 Press the PTT button to make the call.
The green LED lights up.
3 Wait for the Talk Permit Tone to end and speak
clearly into the microphone if enabled.
English
50