User's Guide
Table Of Contents
- Contents
- Supplier's Declaration of Conformity
- Important Safety Information
- Notice to Users (FCC)
- Notice to Users (Industry Canada)
- Software Version
- Intellectual Property and Regulatory Notices
- Computer Software Copyrights
- Radio Care
- Introduction
- Getting Started
- 2.1 Charging the Battery
- 2.2 Attaching the Battery
- 2.3 Attaching the Antenna
- 2.4 Attaching the Carry Holster
- 2.5 Attaching the Universal Connector Cover
- 2.6 Cleaning the Universal Connector Cover
- 2.7 Removing the Universal Connector Cover (Dust Cover)
- 2.8 Turning the Radio On
- 2.9 Turning the Radio Off
- 2.10 Adjusting the Volume
- Radio Controls
- WAVE
- Capacity Max
- 5.1 Push-To-Talk Button
- 5.2 Programmable Buttons
- 5.3 Status Indicators
- 5.4 Registration
- 5.5 Zone and Channel Selections
- 5.6 Calls
- 5.7 Advanced Features
- 5.7.1 Call Queue
- 5.7.2 Priority Call
- 5.7.3 Talkgroup Scan
- 5.7.4 Receive Group List
- 5.7.5 Priority Monitor
- 5.7.6 Multi-Talkgroup Affiliation
- 5.7.7 Talkback
- 5.7.8 Bluetooth®
- 5.7.9 Multi-Site Controls
- 5.7.10 Home Channel Reminder
- 5.7.11 Remote Monitor
- 5.7.12 Call Indicator Settings
- 5.7.13 Call Alert Operation
- 5.7.14 Mute Mode
- 5.7.15 Emergency Operation
- 5.7.16 Text Messaging
- 5.7.17 Privacy
- 5.7.18 Stun/Revive
- 5.7.19 Radio Kill
- 5.7.20 Lone Worker
- 5.7.21 Password Lock
- 5.7.22 Over-the-Air Programming
- 5.7.23 Wi-Fi Operation
- 5.8 Utilities
- 5.8.1 Checking Battery Strength
- 5.8.2 Text-to-Speech
- 5.8.3 Turning the Acoustic Feedback Suppressor Feature On or Off
- 5.8.4 Turning Global Navigation Satellite System On or Off
- 5.8.5 Turning Radio Tones/Alerts On or Off
- 5.8.6 Power Levels
- 5.8.7 Turning Option Board On or Off
- 5.8.8 Turning Voice Announcement On or Off
- 5.8.9 Switching Audio Route between Internal Radio Speaker and Wired Accessory
- 5.8.10 Turning Intelligent Audio On or Off
- 5.8.11 Turning Trill Enhancement On or Off
- Connect Plus
- 6.1 Additional Radio Controls in Connect Plus Mode
- 6.2 Making and Receiving Calls in Connect Plus Mode
2.7
Removing the Universal Connector
Cover (Dust Cover)
1 Push the latch downwards.
2 Lift the cover up and slide down the dust cover from
the universal connector to remove it.
Replace the dust cover when the universal connector is not
in use.
2.8
Turning the Radio On
Rotate the On/Off/Volume Control knob clockwise
until it clicks.
If successful, your radio shows the following indications:
•
A tone sounds.
NOTE:
If the Tones/Alerts function is disabled, there is
no tone upon powering up.
• The green LED lights up.
NOTE:
During the initial power-up after a software version
update to R02.07.00.0000 or later, a GNSS
firmware upgrade takes place for 20 seconds. After
the upgrade, the radio resets and turns on. This
firmware upgrade is only applicable for portable
models with the latest software and hardware.
If your radio does not power up, check your battery. Make
sure that the battery is charged and properly attached.
Contact your dealer if your radio still does not power up.
2.9
Turning the Radio Off
Rotate the On/Off/Volume Control knob
counterclockwise until it clicks.
2.10
Adjusting the Volume
To adjust the volume of your radio, perform one of
the following actions:
•
To increase the volume, turn the On/Off/Volume
Control knob clockwise.
English
33