Declaration of Conformity

Table Of Contents
English
51
2.7
Removing the Universal Connector
Cover (Dust Cover)
1 Push the latch downwards.
2 Lift the cover up and slide down the dust cover from
the universal connector to remove it.
Replace the dust cover when the universal connector is not
in use.
2.8
Turning the Radio On
Rotate the On/Off/Volume Control knob clockwise
until it clicks.
If successful, your radio shows the following indications:
A tone sounds.
NOTE:
If the Tones/Alerts function is disabled, there is
no tone upon powering up.
The green LED lights up.
The display shows MOTOTRBO (TM), followed by a
welcome message or image.
The Home screen lights up.
NOTE:
During the initial power-up after a software version
update to R02.07.00.0000 or later, a GNSS
firmware upgrade takes place for 20 seconds. After
the upgrade, the radio resets and turns on. This
firmware upgrade is only applicable for portable
models with the latest software and hardware.
If your radio does not power up, check your battery. Make
sure that the battery is charged and properly attached.
Contact your dealer if your radio still does not power up.
2.9
Turning the Radio Off
Rotate the On/Off/Volume Control knob
counterclockwise until it clicks.
The display shows Powering Down.