Declaration of Conformity

English
274
6.3.7
Editing the Scan List
NOTE:
If the scan list entry happens to be the currently
selected group, the radio listens for activity on this
group regardless of whether the list entry currently
shows a check mark or not. Whenever a radio is
not in a call, the radio listens for activity on its
Selected Group, Multi-group, the Site All Call, and
its Default Emergency Revert Group (if configured
for one). This operation cannot be disabled. If Scan
is enabled the radio will also listen for activity on
enabled Zone Scan List members.
Your scan list determines which groups can be scanned.
The list is created when your radio is programmed. If your
radio has been programmed to allow you to edit the scan
list, you can:
• Enable/disable scan for individual groups on the list.
• Add and Remove the scan members from the Add
Member menu. Refer to
Add or Delete a Group via the
Add Members Menu on page 275.
NOTE:
A Scan List member must be a regular Group
Contact (not Multi-group or Site All Call/Network
Wide All Call) that is currently assigned to a
Channel Selector position in a Connect Plus Zone
with the same Network ID as the currently selected
Zone.
The Talkgroup alias must not match any Talkgroup
that has been included in the current Zone Scan
List.
1
Press to access the menu.
2
Press or to View/Edit List and press
to select.
3
Press or to the desired Group name.
If a check mark precedes the Group name, then
scan is currently enabled for this Group.
If there is no check mark preceding the Group name,
then scan is currently disabled for this Group.