Declaration of Conformity

English
116
• Replace the existing scan list with a new scan list.
If a talkgroup is programmed as Permanent Talkgroup, you
are unable to edit the talkgroup from the scan list.
IMPORTANT:
To add member into the list, the talkgroup must first
be configured in the radio.
NOTE:
Receive Group List is programmed by the system
administrator. Check with your dealer or system
administrator for more information.
5.7.5
Priority Monitor
The Priority Monitor feature allows the radio to
automatically receive transmission from talkgroups with
higher priority even when radio is in a talkgroup call.
Radio leaves lower priority talkgroup call for higher priority
talkgroup call.
NOTE:
This feature can only be accessed when Talkgroup
Scan feature is enabled.
Priority Monitor feature applies only to members in the
Receive Group List. There are two Priority Talkgroups:
Priority 1 (P1) and Priority 2 (P2). P1 has higher priority
than P2. In Capacity Max system, the radio receives
transmission according to the priority order below:
1 Emergency Call for P1 Talkgroup
2 Emergency Call for P2 Talkgroup
3 Emergency Call for Non-priority Talkgroups in the
Receive Group List
4 All Call
5 P1 Talkgroup Call
6 P2 Talkgroup Call
7 Non-priority Talkgroups in the Receive Group List
See
Editing Priority for a Talkgroup on page 117 for more
information on how to add, remove, and/or edit the priority
of the talkgroups in the scan list.
NOTE:
This feature is programmed by the system
administrator. Check with your dealer or system
administrator for more information.