User's Guide
Table Of Contents
- English
- Contents
- Supplier's Declaration of Conformity
- Important Safety Information
- Notice to Users (FCC)
- Notice to Users (Industry Canada)
- Software Version
- Intellectual Property and Regulatory Notices
- Computer Software Copyrights
- Radio Care
- Introduction
- Getting Started
- Radio Controls
- Status Indicators
- Channel Selections
- Calls
- Advanced Features
- Utilities
- Authorized Accessories List
- Batteries Warranty
- Limited Warranty
a To enter the first digit of the password, use the
Channel Selector Knob.
b To enter each digit of the remaining three digits of
the password, press Side Button 1 or 2.
When the second digit of the password is
entered, your radio ignores any Channel Selector
Knob position change.
A positive tone sounds for every digit entered.
2 Your radio automatically checks the validity of the
password when you enter the last digit of the
password.
If you enter the password correctly, the radio powers up.
If you enter the wrong password after the first and second
attempt, your radio shows the following indications:
• A continuous tone sounds.
Repeat
step 1.
If you enter the wrong password after the third attempt,
your radio shows the following indications:
• A tone sounds.
• The yellow LED double blinks.
• Your radio enters into locked state for 15 minutes.
Wait for the 15-minute locked state timer to end and then
repeat step 1.
NOTE:
If you turn off and turn your radio on again, the
15-minute timer restarts.
7.10.2
Unlocking Radios in Locked State
Your radio is unable to receive calls in locked state. Follow
the procedure to unlock your radio in locked state.
Do one of the following:
• If the radio is powered on, wait for 15 minutes and
then repeat the steps in
Accessing the Radio by Using
Password on page 43 to access the radio.
• If the radio is powered off, power up the radio. Your
radio restarts the 15-minute timer for locked state.
A tone sounds. The yellow LED double blinks.
English
44