User's Guide
Table Of Contents
- English
- Contents
- Supplier's Declaration of Conformity
- Important Safety Information
- Notice to Users (FCC)
- Notice to Users (Industry Canada)
- Software Version
- Intellectual Property and Regulatory Notices
- Computer Software Copyrights
- Radio Care
- Introduction
- Getting Started
- Radio Controls
- Status Indicators
- Channel Selections
- Calls
- Advanced Features
- Utilities
- Authorized Accessories List
- Batteries Warranty
- Limited Warranty
You cannot respond to an All Call.
NOTE:
The radio stops receiving the All Call if you switch to
a different channel while receiving the call. You are
not
able to continue with any programmed button
functions until the end of an All Call.
6.4
Selective Calls
A Selective Call is a call from an individual radio to another
individual radio. It is a Private Call on an analog system.
6.4.1
Responding to Selective Calls
Follow the procedure to respond to Selective Calls on your
radio.
When you receive a Selective Call:
• The green LED blinks.
•
Your radio unmutes and the incoming call sounds
through the speaker.
1 Press the PTT button to respond to the call.
The green LED lights up.
2 Wait for the Talk Permit Tone to end and speak
clearly into the microphone if enabled.
3 Release the PTT button to listen.
The call ends when there is no voice activity for a
predetermined period.
6.5
Broadcast Voice Calls
A Broadcast Voice Call is a one-way voice call from any
user to an entire talkgroup.
The Broadcast Voice Call feature allows only the call
initiating user to transmit to the talkgroup, while the
recipients of the call cannot respond (no Call Hang Time).
Your radio must be programmed to allow you to use this
feature. Check with your dealer or system administrator for
more information.
English
33